Washing Machine Installation

Masters of the service centre service equipment of various brands Bosch, Electrolux, Zanussi, Ariston and others.

Our employees take into account the peculiarities of different manufacturers and models. The manufacturer’s recommendations are observed and applied exclusively original spare parts.

Samsung, LG, Whirlpool, Maytag, GE, Frigidaire, Electrolux, Speed Queen, Miele, Bosch, Splendide, Spin-X, Staber, Sports Laundry Systems, UniMac, Maytag Commercial Laundry, Advance Energy Tech., Modern Maid

Professional washer installation service ensuring proper setup, secure connections, and optimal performance for your washing machine. We handle water supply, drainage, leveling, and testing for safe and efficient operation.

Proper washing machine installation is essential for its long-lasting and trouble-free operation. Incorrect setup can lead to leaks, vibrations, and even damage. This article provides a detailed DIY installation guide covering all technical requirements.

🔹 Preparation for Installation
1. Choosing the Location
Flat, solid surface (tile, concrete).
Close to utilities (water supply, drain, electrical outlet).

Clearances:
5–10 inches from the wall,
1–2 inches on the sides for ventilation.

⚠️ Do not:
Place on soft surfaces (carpet, unsupported linoleum).
Install too close to walls or other appliances.

2. Required Tools
Level
Wrench (for transport bolts)
Hoses (if not included)
Teflon tape (for sealing connections)

🔹 Step-by-Step Installation
1. Unpacking and Removing Transport Bolts
Remove all packaging and foam.
Unscrew the support bolts on the back (usually 4–6).
Plug the holes with the provided caps.

❌ Leaving bolts installed may cause drum damage during spinning.

2. Leveling the Machine
Place the machine in position.
Adjust the feet:
Loosen the lock nuts,
Screw feet to desired height,
Tighten lock nuts.
Use a level to verify (max 2° tilt allowed).

📌 Tip: Place a rubber mat or anti-vibration pads underneath to reduce noise.

3. Connecting the Water Supply
Connect the water inlet hose (usually blue-marked) to the machine’s inlet valve and the water tap (use adapter if needed).
Check for leaks by turning on the water and inspecting all joints.

⚠️ Important:
Avoid kinking the hoses.
If water is hard, install a coarse water filter.

4. Setting Up the Drain
Drain options:
Through a standpipe or siphon into the sewage system (preferred).
Into a bathtub or sink (temporary solution).
Secure the drain hose at 20–32 inches above the floor to prevent backflow.

❌ Common mistakes:
Hose resting on floor can cause water backflow.
Kinks in the hose block drainage.

5. Electrical Connection
Outlet must be:
Properly grounded,
Located away from water,
With 220V supply.
Do not use extension cords — plug directly into the outlet.

🔹 First Run and Checks
Run the washing machine on an empty cycle or “rinse and spin.”
Check for:
Water inlet leaks,
Proper drainage,
Excessive vibrations during spin.

🔹 Common Installation Mistakes
Mistake Consequences
Transport bolts not removed Drum damage
Uneven leveling Loud noise, bearing failure
Kinked hoses Water inlet or drainage errors
Poor grounding Electric shock, electronic damage

🔹 When to Call a Professional?
No existing plumbing connections (need to add taps or drainage).
Washer-dryer combos (require specialist installation).
Unsure about your skills (better pay for professional installation than repairs).

🔹 Summary
Proper washing machine installation includes:
✅ Removing transport bolts
✅ Leveling the machine
✅ Sealing water and drain connections
✅ Testing before use

🛠 Need help? The Service offers full installation services with warranty!