Self-repair of the washing machine: detailed step-by-step instructions for self-repair of frequent breakdowns
Would you like to learn about troubleshooting your washing machine yourself? We offer detailed step-by-step instructions to help you deal with common problems without having to call a repairman to fix your appliance.
It may seem that going to a service center or washing machine repair center is the obvious solution to a washing machine problem. However, in some cases, you can try to repair your washing machine without a service center. This article provides step-by-step instructions for some basic troubleshooting.
Before you start repairing your washer, it’s important to read the manual and understand how it functions. Also, remember to be safe – unplug the machine, turn off the water supply, and wear gloves and safety glasses when dealing with electronics and chemicals. Repair tools such as screwdrivers, wrenches, and pliers will come in handy.
Clogged filter
That’s actually one of the most common problems
– Verify that the drain pump filter is not clogged.
– Verify there are no contaminants in the drain hoses.
– Verify there is no problem with the drain pump and replace if necessary.
If your washer is not spinning the drum, not draining water, or is running erratically, the cause may be a clogged water filter. You will need to locate the filter on the machine (usually at the bottom of the front panel) and remove it to clean it. We recommend wearing protective gloves and a towel to avoid spilling water. Remove all dirt and debris from the filter, then reinstall the filter and check for proper operation.
The washing machine does not spin the drum.
– Check if there are any objects in the drum.
– Make sure that the belt is in place and not broken.
In the event of an error message or the appliance’s inability to start the spin cycle, it is advisable to inspect the drive belt. If the belt is damaged, such as torn or stretched, it should be replaced. To do so, the user must first remove the back or top panel of the washing machine to gain access to the drive mechanism. Once this is done, the old belt can be removed and the new belt installed according to the instructions in the owner’s manual.
The washing machine does not drain or draw water.
It is recommended the following inspections be carried out:
- An examination of the drain pump filter should be conducted to ascertain whether it is clogged.
- The drain hoses should be inspected for the presence of dirt.
If your washing machine isn’t drawing water, it might be because the pump is clogged. You’ll find the drain pump in the machine’s drain pipe. You might need to remove the back cover to clean it.
Difficulty closing the door of the washing machine.
This may be caused by incorrect positioning of the drum or the door lock, which may be broken. Before calling a technician, try to check if the drum is correctly positioned and if it is not stuck. If that doesn’t help, check the door lock and make sure it’s not damaged. If the lock is broken, you will need to replace it. In this case, it is better to contact a specialist.
Washing machine makes noise or vibrates
The issue may be due to uneven installation of the machine or unbalanced laundry. The first thing to check is that the machine is correctly installed and on a level surface. Next, verify that the laundry is properly distributed inside the drum. If in case the problem persists, it may be due to broken shock absorbers or springs.
Washing machine does not heat water
There are two possible issues with the thermostat: it may be broken, or it may require replacement. To replace these parts, you will need to access the back of the machine and follow the instructions in the user manual.
Doing your own washing machine repairs may not only be cost-effective, but also fun. Don’t be afraid to experiment and keep caution in mind. Just follow our tips and your washing machine will be functioning like new!
Hopefully, this post will give you some help in solving some typical washing machine problems with your own hands. In case you doubt your repair skills, it is always better to contact professionals to protect your washing machine from additional damage.
Сall us (510) 671-1772 or fill out an application and we recall you.